Fenix PD35 V2.0 1000 Lumen XP-L HI V3 Flashlight 1 x 18650 Battery Cree XP-L HI V3 LED

Fenix Reviews
Share
Fenix PD35 V2.0 1000 Lumen XP-L HI V3 Flashlight 1 x 18650 Battery Cree XP-L HI V3 LED
Cree XP-L HI V3 LED with a lifespan of 50,000 hours
Powered by one 18650 rechargeable Li-ion battery or two 3V CR123A Lithium batteries (not included) – the battery indicator light only functions when using the rechargeable battery.
Boot-up battery level indicator and low-voltage warning
Digitally regulated output maintains constant brightness
Reverse polarity protection, protects from improper battery insertion
Anti-roll and anti-slip body design
Tactical tail switch features instant activation
Metal side switch for output selection
Made of durable high-strength and oxidation-resistant 6061 aluminum
Premium type HAIII hard-anodized anti-abrasive finish
Toughened ultra-clear glass lens with an anti-reflective coating

Switches
The tail switch is the tactical switch, and the side switch is the functional switch.

ON/OFF
Tap
Slightly tap the tactical switch to momentarily turn on the light, release it the light will go out.
Fully press
Fully press the tactical switch to constantly turn on the light, press once again to turn off the light.

Output Selection
With the light switched on, single click the functional switch to cycle through Eco→Low→Med→High→Turbo.

Strobe
With the light switched on, press and hold the functional switch for 0.5 seconds to enter strobe, click once again to return back to General mode.

Boot-up Battery Level Indication
Each time the light is turned on, the battery level indicator will automatically display the battery status for 3 seconds.
Green constant on: saturated
Green flashes: sufficient
Red constant on: poor
Red flashes: critical
Note: This only works on rechargeable LI-ion 18650 battery.

Battery Replacement
Unscrew the tail cap to insert the battery with the anode side (+) towards the light head, then screw the tail cap back on.
Low-voltage Warning
When the voltage level drops below 3V, the flashlight is programmed to downshift to a lower brightness level until Eco output is reached. When this happens in Eco output mode, the battery level indicator will display red and the flashlight blinks every three seconds to remind you to replace the battery. To ensure normal use, the flashlight will work until the battery runs out or the battery over-discharging protection activates. Note: This only works on rechargeable LI-ion 18650 battery.

Intelligent Memory Circuit
The light memorizes the last selected brightness level on General mode. When turned on again the previously used brightness level will be recalled.

Intelligent Protection
The light will accumulate a lot of heat when it is working at Turbo mode. When the light is overheated up to 65°C or above, the flashlight will automatically step down a few lumens to reduce the temperature; when the temperature is lower than 65°C, the output will gradually return to Turbo output level.

Usage and Maintenance

Disassembling the sealed head can cause damage to the light and will void the warranty.
Fenix recommends using an excellent quality battery.
If the light will not be used for an extended period, remove the battery, or the light could be damaged by electrolyte leakage or battery explosion.
Unscrew the tail cap half a turn or take out the battery to prevent accidental activation during storage or transportation.
Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare.
Periodic cleaning of the battery contacts improves the lamp’s performance as dirty contacts may cause the lamp to flicker, shine intermittently or even fail to illuminate for the following reasons:
A: The battery needs replacing.
Solution: Replace battery (Ensure battery is inserted according to the manufacturer’s specifications).
B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.
If the above methods don’t work, please contact your authorized distributor.

Warning
This flashlight is a high-intensity lighting device capable of causing eye damage to the user or others. Avoid shining the flashlight directly into anyone’s eyes.
MODEL
Fenix PD35 V2.0 1000 Lumen XP-L HI V3 Flashlight
SKU
FEN-PD35TACV2.0
MANUFACTURER
Black Diamond
COLOR
Black
LED TINT
Cool
Reviews
review-image
Shopping Cart

Your cart is currently empty.