The Quark 123² Turbo X has all of the same great features as the original Quark 123² Turbo and features CREE's new XM-L emitter! The XM-L is a slightly larger emitter, so the Turbo X received an updated, larger smooth reflector to maintain a great balance between light throw distance and spill area.

 

 

 

 

Overview / Main Features

 

Power:Two CR123A Batteries (3.0V~9.0V)

Output: Maximum - 450 lumens; Moonlight - 0.3 lumens

Runtime: Maximum - 1.5 hours; Moonlight - 20 days

Strobe:Strobe, S.O.S., and Beacon flash modes

Specifications<

 

• Powered by: 2 CR123A batteries (included)
• LED Emitter: Premium Cree XM-L R5
• Voltage range: 3.0V ~ 9.0V
• Dimensions
• Length: 5.2 inches
• Diameter: Body 0.86 inches Head: 1.52
• Weight: 4.7 ounces
• 5 Current Regulated Output Levels
• 3 Flash modes: Strobe, SOS, Beacon
• Momentary Activation
• Level Memorization
• Square threads for lifetime smooth operation
• Type III Hard Anodized finish
• Fully knurled
• Reversable/Removable Clip
• Flexible & secure hand grip accessory
• IPX-8 Waterproofing
• Impact-resistant glass lens with Dual-coating - sapphire coating on the outside and anti-reflective coating on the inside for optimal efficiency and durability.
• T-6061 Aircraft-grade Aluminum Body
• Included accessories: lanyard, handgrip, holster, instruction manual

Typical Output Levels and Runtimes + (LED drive current)

Moonlight: 0.3 lumens for 20 days
Low: 8 lumens for 2.6 days
Medium: 60 lumens for 13 hours
High: 260 lumens for 3 hours (250ma)
Max: 450 lumens for 1.5 hours (990ma)
Strobe: 450 lumens for 3 hours
SOS: 450 lumens for 6 hours
 0-450 lumens pulse for 15 hours

The Quark Tactical can memorize any two modes of output, from its eight total modes, to be instantly available. These two memorized modes are accessed by either tightening or loosening the head (for example, tight can be Max, and loose can be Low).

Programming Modes:
To have your Quark Tactical memorize a different mode, turn it on and loosen the head by a half-turn. Then, tighten the head at least four times rapidly (twisting it tight, then loose, then tight, etc., four times). After the fourth time, leave the head tight or loose depending which position you want to program.

After three seconds, the light will flash, signaling it is ready to be programmed. Cycle through the eight available modes by clicking the tailcap off and on. The mode sequence is as follows:

Moonlight » Low » Medium » High » Max » SOS » Strobe » Beacon

 

Once you find your desired mode, leave that mode on for ten seconds and the light will flash again, confirming that the mode has been memorized. To cancel programming before it flashes, turn the light off for three seconds.