The Quark Turbo features a larger, deeper reflector for improved throw! This subseries operates the same as the tactical subseries: with a significantly different UI than the regular Quarks. This UI allows the user to program both primary and secondary outputs.

Please note that the specifications below are for the S2 emitter version. The S3 edition will be approximately 7% brighter.

 

Overview / Main Features

 

Power: Two CR123A Batteries (3.0V~9.0V)

Output: Maximum - 200 ANSI lumens; Moonlight - 0.7 ANSI lumens

Runtime: Maximum - 2 hours 30 minutes; Moonlight - 800 hours (over 30 days!)

Strobe: Strobe, S.O.S., and Beacon flash modes

Specifications

 

• Powered by: 2 CR123A batteries (included)
• LED Emitter: Premium Cree XP-G S2
• Voltage range: 3.0V ~ 9.0V
• Dimensions

Length: 4.9 inches
Diameter (Body): 0.86 inches
Diameter (Head): 1.2 inches
Weight: 2.8 ounces

• 5 Current Regulated Output Levels
• 3 Flash modes: Strobe, SOS, Beacon
• Momentary Activation
• Level Memorization
• Square threads for lifetime smooth operation
• Type III Hard Anodized finish
• Fully knurled
• Reversable/Removable Clip
• Flexible & secure hand grip accessory
• IPX-8 Waterproofing
• Impact-resistant glass lens with Dual-coating - sapphire coating on the outside and anti-reflective coating on the inside for optimal efficiency and durability.

Typical Output Levels and Runtimes + (LED drive current)

Moonlight: 0.7 lumens for 800 hours, (1ma)
Low: 4 lumens for 120 hours (10ma)
Medium: 19 lumens for 20 hours (50ma)
High: 83 lumens for 4.5 hours (250ma)
Max: 200 lumens for 2 hours 30 minutes (990ma)
Strobe: 200 lumens for 3 hours
Beacon: 0-200 lumens pulse for 23 hours

The Quark Tactical can memorize any two modes of output, from its eight total modes, to be instantly available. These two memorized modes are accessed by either tightening or loosening the head (for example, tight can be Max, and loose can be Low).

Programming Modes:
To have your Quark Tactical memorize a different mode, turn it on and loosen the head by a half-turn. Then, tighten the head at least four times rapidly (twisting it tight, then loose, then tight, etc., four times). After the fourth time, leave the head tight or loose depending which position you want to program.

After three seconds, the light will flash, signaling it is ready to be programmed. Cycle through the eight available modes by clicking the tailcap off and on. The mode sequence is as follows:

Moonlight » Low » Medium » High » Max » SOS » Strobe » Beacon

 

Once you find your desired mode, leave that mode on for ten seconds and the light will flash again, confirming that the mode has been memorized. To cancel programming before it flashes, turn the light off for three seconds.